View TLP106_337646.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

TLP106
Preliminary
TOSHIBA PHOTOCOUPLER GaAlAs IRED & PHOTO-IC
TLP106
Unit in mm
Intelligent Power Module Signal Isolation Industrial Inverters Moter Drive
The Toshiba TLP106 consists of a GaAl As light emitting diode and a integrated high gain, high speed photo detector. TLP106 is suitable for input control signals isolation of IPM. This unit is MFSOP 6pin. The detector has a totem pole output stage that provides source drive and sink drive, and built-in Schmitt trigger. The detector IC has an internal shield that provides a guaranteed common mode transient immunity of 10kV/E s. TLP106 is a buffer logic type. For inverter logic type, TLP102 is in line-up. l l l l l l l Buffer logic type (totem pole output) Guaranteed Performance Over temperature : -40~85C Power Supply Voltage : -0.5~20V Input Current : IFLH=3mA(Max.) Switching Time (tpLH/tpHL) : 400ns(Max.) Common mode transient immunity : 10kV/us Isolation Voltage : 3750Vrms JEDEC TOSHIBA Weight: 0.09 g
11-4C2
Truth Table
Input H L LED ON OFF Tr1 ON OFF Tr2 OFF ON Output H L
Pin Configuration (top View) 1
VCC
6 5
1:ANODE 3:CATHODE 4:GND 5:VO 6:VCC
3
GND SHIELD
4
Schematic
IF 1*{ VF 3*| Tr2 Tr1
ICC VCC 6 IO 5 VO
SHIELD
GND 4
0.1uF bypass capacitor must be connected between pin 6 and 4
1
2003-10-20
TLP106
Recommended Operating Conditions
CHARACTERISTIC Input Current , ON Input Voltage , OFF Supply Voltage Operating Temperature SYMBOL IF(ON) VF(OFF) VCC Topr MIN. 5 0 4.5 -40 TYP. MAX. 10 0.8 20 85 UNIT mA V V C
Maximum Ratings (Ta=25C)
CHARACTERISTIC Forward Current LED Peak Transient Forward Current Reverse Voltage Output Current 1 (Ta=25C) DETECTOR Output Current 2 (Ta=85C) Peak Output Current Output Voltage Supply Voltage Operating Temperature Range Storage Temperature Range Lead Solder Temperature(10s) Isolation Voltage (AC,1min.,R.H.=60%,Ta=25C) (Note2) (Note1) SYMBOL IF IFPT VR IO1 IO2 IOP VO VCC Topr Tstg Tsol BVs RATING 20 1 5 15/-15 4.5/-4.5 20/-20 -0.5~20 -0.5~20 -40~85 -55~125 260 3750 UNIT mA A V mA mA mA V V C C C Vrms
Note1 : Pulse width PW=10us,500pps. Note2 : Device Considered a two terminal device : pins 1 and 3 shorted together and pins 4,5 and 6 shorted together.
2
2003-10-20
TLP106
Electrical Characteristics (Unless otherwise specified, Ta=-40 to 85C,VCC=4.5~20V)
CHARACTERISTIC Input Forward Voltage Temperature Coefficient of Forward Voltage Input Reverse Current Input Capacitance Logic Low Output Voltage Logic High Output Voltage SYMBOL VF ?VF/?Ta IR CT VOL VOH CONDITION IF=5mA ,T a=25C IF=5mA VR=5V,Ta=25C V=0,f=1MHz,Ta=25C IOL=3.5mA,VF=0.8V IOH=-3.5mA,IF=5mA VCC=5V VCC=20V Logic Low Supply Current ICCL VF=0V VCC=20V , Ta=-40~85C VCC=5V , Ta= 25C Logic High Supply Current Logic Low Short Circuit Output Current Logic High Short Circuit Output Current Input Current Logic High Output Input Voltage Logic Low Output Input Current Hysteresis ICCH IF=5mA VF=0V VCC=VO=20V IF=5mA , VO=GND VCC=20V IO=-3.5mA,VO>2.4V VCC=20V , Ta=-40~85C VCC=5V , Ta= 25C IOSL MIN. 2.4 17.4 7 TYP. 1.5 -2.0 30 0.1 2.58 18.1 3.8 3.8 37 MAX. 1.7 10 0.35 6.0 4.5 6.0 4.5 mA mA mA UNIT V mV/C E A pF V V
IOSH
-7
40
-
mA
IFLH
-
0.3
3
mA
VFHL IHYS
IO=3.5mA,VO<0.4V VCC=5V
0.8 -
0.05
-
V mA
*All typical values are at Ta=25C,VCC=5V,IF=(ON)=5mA unless otherwise specified
Isolation Characteristics (Ta = 25C)
Characteristic Capacitance input to output Isolation resistance Symbol CS RS Test Condition V = 0,f = 1MHz R.H. = 60%,VS = 500V (Note 2) AC,1 minute Isolation voltage BVS AC,1 second,in oil DC,1 minute,in oil (Note 2) Min. ? 1x10
12
Typ. 0.8 10 ? 10000 10000
14
Max. ? ? ? ?
Unit pF O Vrms Vdc
3750 ? ?
?
3
2003-10-20
TLP106
Switching Characteristics (Unless otherwise specified, Ta=-40 to 85C,VCC=4.5~20V*j
CHARACTERISTIC Propagation Delay Time to Logic High output Propagation Delay Time to Logic Low output Switching Time Dispersion between ON and OFF Output Rise Time Output Fall Time Common Mode transient Immunity at High Level Output Common Mode transient Immunity at Low Level Output *All typical values are at Ta=25C CML CMH 2 VCM=1000Vp-p,IF=0mA, VCC=20V,Ta=25C 10000 V/us SYMBOL tpLH TEST CIR-CUIT CONDITION IF=0? 5mA CL=100pF IF=5? 0mA 1 |tpHLtpLH| ' " " CL=100pF CL=100PF IF=0? 5mA,VCC=5V IF=5? 0mA,VCC=5V VCM=1000Vp-p,IF=5mA, VCC=20V,Ta=25C MIN. 50 TYP. 250 MAX. 400 UNIT ns
tpHL
50
270
400
ns
-
35 20
350 -
ns ns ns
-10000
-
-
V/us
TEST CIRCUIT 1:Switching Time Test Circuit
IF
VCC 0.1uF
VO VCC
GND SHIELD
CL
IF
VO
1.3V
1.3V
tpLH
tpHL
4
2003-10-20
TLP106
TEST CIRCUIT 2:Common Mode Transient Immunity Test circuit
SW
A B
IF
*
P
VCC
6 0.1uF VO VCC GND 4 SHIELD VCl
5 3
1000u 90%
VCM
10%
tr
tf
*E W S
A : IF=5mA
17V
CM H
CM H**
800(V) tf(us)
VO
*E W S
B : IF=0mA
PV
CM L
CM L**
800(V) tr(us)
VOL Test Circuit
1 VCC 5 3 SHIELD GND 4 0.1uF * VOL IOL V
*
VOH Test Circuit
IF * 1 VCC 5 3 SHIELD GND 4 V VOH IOH * VCC 0.1uF 6
6
VCC
IOSL Test Circuit
1 VCC 5 3 SHIELD GND 4 0.1uF
A *
IOSH Test Circuit
IF * 1 VCC 5 VCC VO 3 SHIELD GND 4 0.1uF
A VO
6
6
*(c) IOSL
* IOSH
VCC
5
2003-10-20
TLP106
VO - Ta L H VO - Ta
1 F 0.9 VL=1. 05V I O =10m*@ A 0.8 0.7 0.6 0.5 0.4 0.3 V cc=20V 0.2 V cc=5. 5V 0.1 0 -40 -20 0 20
30
Logi c Hi gh O put Vol t age ut VO ( V) H
Logi c Low O put Vol t age ut VO V) L(
25 20 15 10 5
I F =5m A IO =-10m A H
V cc=20V
V cc=4. 5V
40
60
80 100 120
0 -40 -20
0
20
40
60
80 100 120
Am ent Tem at ur e Ta( *Z bi per )
Am ent Tem at ur e Ta( *Z bi per )
IC L - Ta C
C I C H - Ta
10 8
IC L( m A) C Logi c Hi gh Suppl y Cur r ent Logi c Low Suppl y Cur r ent
10
I F =5m A
8
I C H( m A) C
6 4 2 0 -40 -20
V 20V cc= V cc=5. 5V
6 4
V cc=20V
2 0 -40 -20
V cc=5. 5V
0
20
40
60
80 100 120
Am ent Tem bi perat ur e Ta( *Z )
0
20
40
60
80 100 120
Am ent Tem at ur e Ta( *Z bi per )
S IOL - Ta
I OH - Ta S
50 40 30 20 10 0 -40 -20
V =5. 5V o V cc=5. 5V
-50
Logi c H gh Shor t C r cui t i i O put C r ent I O H( m ut ur S A) V = 0V o
V= o 20V V 20V cc=
Logi c Low Short Ci r cui t O put Curr ent I O ( m ut SL A)
-40
V cc=20V
-30 -20 -10 0 -40 -20 0 20 40 60 80 100 120 Am ent Tem at ur e Ta( *Z bi per )
V 5.5V cc=
0
20
40
60
80 100 120
Am ent Tem bi perat ur e Ta( *Z )
6
2003-10-20
TLP106
L IF H - Ta I nput Cur rent Logi c H gh O put i ut
t pHL, t pLH - Ta
5 Pr opagat i on Del ay Ti m e t pLH/ t pHL[ ns]
IO =-10m A H
500
I F =5m A V cc=20V CL , =100pF
4
I FLH( m A)
400
t pLH
3 2 1 0 -40 -20
V cc=20V V cc=4. 5V
300
t pH L
200 100 0 -40 -20 0 20 40 60 80 100 120 Am ent Tem at ur e Ta( *Z bi per )
0
20
40
60
80 100 120
Am ent Tem at ure Ta( *Z bi per )
7
2003-10-20
TLP106
RESTRICTIONS ON PRODUCT USE
* The information contained herein is subject to change without notice.
030619EBC
* The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by TOSHIBA for any infringements of patents or other rights of the third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of TOSHIBA or others. * TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of such TOSHIBA products could cause loss of human life, bodily injury or damage to property. In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and conditions set forth in the "Handling Guide for Semiconductor Devices," or "TOSHIBA Semiconductor Reliability Handbook" etc.. * The TOSHIBA products listed in this document are intended for usage in general electronics applications (computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.). These TOSHIBA products are neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or bodily injury ("Unintended Usage"). Unintended Usage include atomic energy control instruments, airplane or spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments, medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in this document shall be made at the customer's own risk. * The products described in this document are subject to the foreign exchange and foreign trade laws. * TOSHIBA products should not be embedded to the downstream products which are prohibited to be produced and sold, under any law and regulations. * GaAs(Gallium Arsenide) is used in this product. The dust or vapor is harmful to the human body. Do not break, cut, crush or dissolve chemically.
8
2003-10-20

▲Up To Search▲

Price & Availability of TLP106

	To Download TLP106 Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .